Network-related Problems
479
Problem Solving
15
Mac OS X 10.3.9 - 10.4.11/10.5/10.6/10.7
îš„ When you cannot print
When using EtherTalk
The possible symptoms, causes, and remedies for problems when using EtherTalk are as
follows:
Cause Check point Remedy
The LPD port is not activated. Confirm whether the LPD port
is activated.
When printing with a printer
detected by using Bonjour,
Select the [Enabled] check box
of [LPD] to activate the port.
Symptom Cause Remedy
Documents are printed by
another machine.
If a machine assigned the
same printer name already
existed on the network, the
printer names is automatically
changed when starting the
machine. Therefore, depending
on the timing of starting the
printer, the machine may be
started with a different name,
and documents are printed by
another machine.
A machine that is assigned the
same printer name may exist
on the network. Confirm the
printer name, and change the
name if it is duplicated.
The printer cannot be browsed
from clients.
If the machine is turned on
before it is connected to a
network, clients may not be
able to identify the printer
name and therefore cannot
browse the printer.
Turn the machine on after
connecting to the network. If
the machine is turned on while
disconnected from the
network, turn the machine off,
connect it to the network, and
then turn the machine on
again.
To Next Page
Loading...
Need help?
General
