EasyManuals Logo
Home>Fuji Xerox>All in One Printer>DocuCentre-IV C5575

Fuji Xerox DocuCentre-IV C5575 Administration Guide

Fuji Xerox DocuCentre-IV C5575
731 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #359 background imageLoading...
Page #359 background image
Configuration of Job Flow Sheets
359
Scanner Environment Settings
9
4 Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for obtaining the
addresses. If an IP address cannot be obtained automatically or manual configuration is
preferred, confirm the settings of an IP address, a subnet mask, and a gateway address.
For information on how to set an IP address, refer to "Protocol Settings" (P.201).
5 Select [Close] repeatedly until the [Tools] screen is displayed.
6 Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message displayed on
the screen, follow the message and reboot the machine.
7 Print a configuration report to confirm that the SOAP, SNMP, and Internet Services (HTTP)
ports are enabled and that TCP/IP is set up correctly.
For information on how to print a configuration report, refer to "Print Reports" (P.106).
Step 2 Configuring the SNMP Port
Configure the transport protocol for the SNMP port using CentreWare Internet Services.
1 Start CentreWare Internet Services.
For information on how to start CentreWare Internet Services, refer to "Starting CentreWare Internet Services" (P.312).
2 Configure the transport protocol for the SNMP port.
1) Click the [Properties] tab.
2) Click [ ] on the left of [Connectivity].
3) Click [Port Settings].
4) Select the [UDP] check box under [SNMP].
5) Click [Apply].
6) The right frame of the web browser changes to the machine reboot display.
7) Click [Reboot Machine]. The machine reboots and the settings are enabled.
Step 3 Configuration on the Computer
Create job flows using EasyOperator and Device Setup Tool to use for scanned documents.
Note • EasyOperator is included in the Driver CD Kit. Device Setup Tool is included in ApeosWare
Management Suite, which you can download from our web site. For information on creating job
flows, refer to the manual contained in the Driver CD Kit.

Table of Contents

Other manuals for Fuji Xerox DocuCentre-IV C5575

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox DocuCentre-IV C5575 and is the answer not in the manual?

Fuji Xerox DocuCentre-IV C5575 Specifications

General IconGeneral
BrandFuji Xerox
ModelDocuCentre-IV C5575
CategoryAll in One Printer
LanguageEnglish

Related product manuals