Fax Service Settings
245
Tools
5
There are priority levels from 1 to 3. All priority can be set, however, if you want to display
only one priority level, make the settings of all priority levels the same.
Note • This feature is not available for some models. An optional component is required. For more
information, contact our Customer Support Center.
Direct Fax
Set whether or not to receive a fax, which is instructed using a fax driver from a computer.
When you select [Disabled], the Direct Fax feature becomes unavailable.
Block Inbound Faxes
Set a G3-ID (fax number) from which you want to reject a fax reception. You can specify up
to 50 G3-IDs.
You can find the G3-ID of the sender that you want to reject in "Remote Station" column of
an Activity Report or "Input Source" column of a Job History Report.
Block Unknown Fax Numbers
Set whether or not to receive faxes from unknown G3-ID fax numbers. When [Yes] is
selected, the machine does not receive faxes from unknown fax numbers.
Fax Received Options
Fax Received Options allows you to specify a method for classifying received fax documents
into specified folders.
Folder Selector Setup
If you set the classification by line type, the machine classifies the received documents by
line type and store them in the folders specified.
1 Select [Folder Selector Setup].
2 Select the line to register, and then select
[Change Settings].
Note • The displayed items may vary depending on
the options installed.
3 Select [On].
4 Enter the folder number (three-digits) where you want to store the faxes with the numeric
keypad.
5 Select [Save].
Output Destination Setup
In [Output Destination Setup], you can set the output destination for each receiving line.
To Next Page
Loading...
Need help?
General
