5 Tools
296
Tools
5
Authentication/Security Settings
In [Authentication/Security Settings], you can configure the authentication and security
settings.
For more information about the feature, refer to "Authentication and Accounting Features" (P.401).
The following shows the reference section for each setting.
System Administrator Settings................................................................................................................................................. 296
Authentication ............................................................................................................................................................................. 297
Allow User to Disable Active Settings ..................................................................................................................................... 305
Job Status Default ....................................................................................................................................................................... 305
Overwrite Hard Disk .................................................................................................................................................................... 306
1 On the [Tools] screen, select [Authentication/Security Settings].
For the method of displaying the [Tools] screen, refer to "System Settings Procedure" (P.126).
2 Select an item to set or change.
System Administrator Settings
In [System Administrator Settings], you can set the system administrator ID and passcode.
We recommend setting the system administrator ID and passcode to prevent unauthorized
setting changes and ensure security.
System Administrator's Login ID
Set the system administrator's user ID. Enter the ID from 1 to 32 single-byte characters.
Note • The default of the system administrator's user ID is "11111".
1 Select [System Administrator's Login ID].
2 Select [On].
3 Select [Keyboard].
4 Enter the system administrator's ID with up to
32 characters, and then select [Save].
5 Repeat steps 3 and 4 to re-enter the same
system administrator's ID in [Re-enter System
Administrator's Login ID].
6 Select [Save].
7 A confirmation window appears. Select [Yes] to confirm your entry.
System Administrator's Passcode
Set the passcode for the System Administration mode.
Setting a passcode is strongly recommended to enhance security.
Note • The default of the system administrator's passcode is "x-admin".
The system administrator's passcode set here is used when [Passcode Entry for Control
Panel Login] is set to [On] under [Authentication/Security Settings] > [Passcode Policy].
To Next Page
Loading...
Need help?
General
