106 Using the Operator Panel Menus
Stored Documents
NOTE:
• Stored Documents feature is available only when RAM Disk under System Settings is set to On.
Purpose:
To print a list of all files stored for Secure Print in the RAM disk.
Meter Readings
Use Meter Readings to check the total number of printed pages.
Values:
Admin Menu
Use Admin Menu to configure a variety of printer features.
NOTE:
• A password is required to enter the operator panel menus when Panel Lock Set is set to Enable. In this case, enter the
password you specified, and then press the button.
Network
Use the Network menu to change the printer settings affecting jobs sent to the printer through the wired or wireless
network.
NOTE:
• The value marked by an asterisk (*) is the factory default setting.
•Ethernet
Purpose:
To specify the communication speed and the duplex settings of Ethernet. The change becomes effective after the
printer is turned off and then on.
Values:
NOTE:
• This item is displayed when the Ethernet cable is connected or Wi-Fi is set to Off.
Meter 1 Displays the total number of color prints.
Meter 2 Displays the total number of monochrome prints.
Meter 3 Always shows 0 on your printer.
Meter 4 Displays the total number of color and monochrome prints (Meter 1 + Meter 2).
Auto* Detects the Ethernet settings automatically.
10BASE-T Half Uses 10base-T half-duplex.
10BASE-T Full Uses 10base-T full-duplex.
100BASE-TX Half Uses 100base-TX half-duplex.
100BASE-TX Full Uses 100base-TX full-duplex.
To Next Page
Loading...
Need help?
General
