44 Printer Connection and Software Installation
Configuring Printer and Installing Software on Windows
Identifying Print Driver Pre-install Status (for Network Connection
Setup)
Before installing the print driver on your computer, check the IP address of your printer and change the firewall
settings.
Checking the IP Address for Your Printer
1 Print the System Settings page.
See also:
• "Printing a System Settings Page" on page 101
2 Confirm the IP address under Wired Network or Wireless Network on the System Settings page.
If the IP address is 0.0.0.0, wait for a few minutes to resolve the IP address automatically, and then print the
System Settings page again.
If the IP address is not resolved automatically, see "Assigning an IP Address Manually" on page 40.
Changing the Firewall Settings Before Installing Your Printer
You may need to change the firewall settings before installing the printer software. Contact your network
administrator for more information.
The following procedure uses Windows 7 as an example.
1 Insert the Software Pack CD-ROM into your computer.
2 Click Start Control Panel.
3 Click System and Security.
4 Click Allow a program through Windows Firewall.
5 Click Change settings.
6 Click Allow another program.
7 Click Browse.
8 Enter "D:\setup.exe" (in case your optical disk drive is D) in the File name text box, and then click Open.
9 Click Add.
10 Click OK.
To Next Page
Loading...
Need help?
General
