Printer Connection and Software Installation 45
Using Installer to Set Up Connection and Install Software
NOTE:
• The following procedure sets up printer connection and then install the print driver and software. If you have already
established printer connection, see "Using Installer to Install Software" on page 48 to install the print driver and software
immediately.
Launching the FX Printer Installation Screen
1 Insert the Software Pack CD-ROM into your computer to start the FX Printer Installation screen.
NOTE:
• For Windows 8, Windows 8.1, Windows Server
®
2012, and Windows Server 2012 R2, click the message displayed on
the upper right corner of the screen, and then select Run setup.exe.
• If the CD does not automatically launch, perform the following steps.
a For Windows Server 2003, Windows Server 2003 R2, Windows Server 2008, and Windows Server 2008 R2, click Start
Run.
For Windows Vista
®
and Windows 7, click Start All Programs Accessories Run.
For Windows 8 and Windows Server 2012, right-click on the Start screen and click All apps
Run.
For Windows 8.1 and Windows Server 2012 R2, click on the Start screen Run.
b Enter "D:\setup.exe" (in case your optical disk drive is D), and then click OK.
2 Click Setup Printer and Install Software.
3 If you agree to the terms of the License Agreement, choose I accept the terms of the license agreement,
and then click Next.
To Next Page
Loading...
Need help?
General
