155 Using the Operator Panel Menus
•Protocol
Purpose:
To enable or disable each protocol. The change becomes effective after the printer is turned off and
then on again.
Values:
IPv4 Get IP
Address
DHCP /
Autonet
*
Sets the IP address automatically. A random value in the
range of 169.254.1.0 to 169.254.254.255 that is not currently
in use on the network is set as the IP address. The subnet
mask is set as 255.255.0.0.
BOOTP Sets the IP address using BOOTP.
RARP Sets the IP address using RARP.
DHCP Sets the IP address using DHCP.
Panel Use this option when you want to set the IP address manually
on the operator panel.
IP Address When an IP address is being set manually, the IP is allocated
to the printer using the format nnn.nnn.nnn.nnn. Each octet
that makes up nnn.nnn.nnn.nnn is a value in the range of 0 to
254. 127 and any value in the range of 224 to 254 cannot be
specified for the first octet of a gateway address.
Subnet Mask When an IP address is being set manually, the subnet mask is
specified using the format nnn.nnn.nnn.nnn. Each octet that
makes up nnn.nnn.nnn.nnn is a value in the range of 0 to 255.
255.255.255.255 cannot be specified as the subnet mask.
Gateway Address When an IP address is being set manually, the gateway
address is specified using the format nnn.nnn.nnn.nnn. Each
octet that makes up nnn.nnn.nnn.nnn is a value in the range of
0 to 254. 127 and any value in the range of 224 to 254 cannot
be specified for the first octet of a gateway address.
IPsec Disable
*
Disables IPsec.
LPD Disable Disables the Line Printer Daemon (LPD) port.
Enable
*
Enables the LPD port.
Port9100 Disable Disables the Port9100 port.
Enable
*
Enables the Port9100 port.
FTP Disable Disables the FTP port.
Enable
*
Enables the FTP port.
IPP Disable Disables IPP port.
Enable
*
Enables IPP port.
SMB (TCP/IP) Disable Disables SMB TCP/IP port.
Enable
*
Enables SMB TCP/IP port.
SMB (NetBEUI) Disable Disables SMB Net BEUI port.
Enable
*
Enables SMB Net BEUI port.
WSD Disable Disables WSD port.
Enable
*
Enables WSD port.
SNMP (UDP/IP) Disable Disables the Simple Network Management Protocol (SNMP)
UDP port.
Enable
*
Enables the SNMP UDP port.
To Next Page
Loading...
Need help?
General
