165 Using the Operator Panel Menus
• Auto Adjust Regi
Purpose:
To specify whether to automatically perform color registration adjustment.
Values:
•Adjust ColorRegi
Purpose:
To manually perform color registration adjustment.
Manual Color Registration Adjustments are required when the printer is initially installed and after the
printer is moved.
NOTE:
• The Adjust ColorRegi feature can be configured when Auto Adjust Regi is set to Off.
Values:
NOTE:
• Ensure that you remove the paper from the single sheet feeder (SSF) before performing Auto Adjust.
Labels 0
*
-6 to +6
LW Gloss Card 0
*
-6 to +6
HW Gloss Card 0
*
-6 to +6
Off Does not
automatically perform color registration adjustment.
On
*
Automatically performs color registration adjustment.
Auto Adjust Automatically performs color registration correction.
ColorRegi Chart Prints a color registration chart. The color registration chart prints a
lattice pattern of yellow, magenta, and cyan lines. On the chart, find
the values on the right side that are next to the line that is perfectly
straight for each of the three colors. If the value for this line is 0,
color registration adjustment is not required. If the value for this
line is any value other than 0, specify the adjustment values for
lateral adjustment and process adjustment under Enter Number.
Enter Number LY -9 to +9 Sets lateral (perpendicular to paper feed direction) and process
(paper feed direction) color adjustment values individually for
Yellow, Magenta, and Cyan. Enter a number in order of lateral
adjustment (left), lateral adjustment (right), and process
adjustment. Press the
button to save all the settings.
LM
LC
RY -9 to +9
RM
RC
PY -9 to +9
PM
PC
To Next Page
Loading...
Need help?
General
