Network Basics 72
Identifying Print Driver Pre-install Status (For Network
Connection Setup)
Before installing the print driver on your computer, print the Printer Settings page to check the IP
address of your printer.
This section includes:
• "The Operator Panel" on page 72
• "Disabling the Firewall Before Installing Your Printer" on page 72
The Operator Panel
1 Press the Menu button.
2 Select Report/List, and then press the button.
3 Select Printer Settings, and then press the button.
The Printer Settings page is printed.
4 Find the IP address under Network (Wired) on the Printer Settings page.
If the IP address is 0.0.0.0, wait for a few minutes to resolve the IP address automatically, and
then print the Printer Settings page again.
If the IP address is not resolved automatically, see "Assigning an IP Address (for IPv4 Mode)" on
page 67.
Disabling the Firewall Before Installing Your Printer
NOTE:
• For Windows XP, Service Pack 2 or 3 must be installed.
If you are running one of the following operating systems, you must disable the firewall before
installing the Fuji Xerox printer software:
• Windows 7
• Windows Vista
• Windows Server 2008 R2
• Windows Server 2008
• Windows XP
The following procedure uses Windows XP as an example.
1 Click start → Help and Support.
NOTE:
• For Windows Vista, Windows Server 2008, Windows Server 2008 R2 and Windows 7 operating systems,
if you use Online Help, switch to Offline Help on Windows Help and Support window.
2 In the Search box, enter firewall and then press the Enter key.
In the list, click Turn Windows Firewall on or off and then follow the instructions on the screen.
Enable the firewall after the installation of the Fuji Xerox printer software is complete.
To Next Page
Loading...
Need help?
General
