1. OPERATIONAL OVERVIEW
1-52
1.38.2 How to mute the target alarm
A target in the target alarm zone produces both visual (flashing) and audible (beep)
alarms. To silence the audio alarm select the appropriate target alarm box then press
the left button. The target alarm box indication shows "ALRu MUTE". This will deac-
tivate the audio alarm but will not stop the flashing of the offending target. You can also
stop the alarm by deactivating the target alarm zone (see section 1.38.3).
To reactivate the audio alarm, select the target alarm box then press the left button
until the target alarm box shows "ALRu WORK".
1.38.3 How to deactivate a target alarm
Select the target box to be deactivated, then press and hold the left button.
Note: When both [ALR1] and [ALR2] are active, [ALR2] must be deactivated before
[ALR1] can be deactivated.
If [ALR1] and [ALR2] are active when you try to deactivate [ALR1], the system releas-
es two audible beeps and shows the message "DELETE ALR2 FIRST".
1.38.4 How to change target alarm attributes
You can select the echo strength level that triggers the alarm, the condition that gen-
erates the alarm and the volume of the audio alarm as follows:
1. Open the [MAIN MENU].
2. Select [ALERT], then push the ADJUST knob.
3. Select [TARGET ALARM], then push the ADJUST knob.
4. Select [ALR1 MODE] or [ALR2 MODE] as appropriate, then push the ADJUST
knob.
5. Select [IN] or [OUT] as appropriate, then push the ADJUST knob.
[IN]: Targets entering the alarm zone trigger the alarm.
[OUT]: Targets leaving the alarm zone trigger the alarm.
6. Select [LEVEL], then push the ADJUST knob.
7. Select the appropriate level of echo strength to trigger the alarm, then push the
ADJUST knob. [1] is the highest strength, [4] is the lowest strength.
8. Press the right button once to return to the [ALERT] menu.
9. Select [ALERT SOUND LEVEL], then push the ADJUST knob.
10. Select [OFF], [LOW], [MID] or [HIGH] as appropriate, then push the ADJUST
knob.
Note: This setting is applied to all alarms output from this radar system.
11. Close the menu.
To Next Page
Loading...
Need help?
General
