Capture
An event-related picture will be captured when the selected event happens.
Recording
An event-related picture will be captured when the selected event happens.
Note
The device should support recording.
Buzzer on Reader
The audible warning of card reader will be triggered.
Alarm Output
The alarm output will be triggered for nocaon when the selected event happens
Alarm Input
Arm or disarm the alarm input.
Note
The device should support alarm input funcon.
Access Point
The door status of open, close, remain open, or remain close will be triggered.
Note
The target door and the source door cannot be the same one.
Audio Play
The audio prompt will be triggered. And the select audio index related audio content will be
played according to the
congured play mode.
7.
Click Save.
8.
Oponal: Aer adding the device linkage, you can do one or more of the followings:
Edit Linkage
Sengs
Select the congured linkage sengs in the device list and you can edit its
event source parameters, including event source and linkage target.
Delete Linkage
Sengs
Select the congured linkage sengs in the device list and click Delete to
delete it.
9.8.3 Congure Device Acons for Card Swiping
You enable access control device's linkage acons (such as disarming a zone and triggering audio
prompt) for the swiping of a specic card, In this way, you can monitor the card holder's behaviors
and whereabouts.
DS-K1TA70 Series Face Recognion Terminal User Manual
156