8. TRANSPORTING
Before transporting the outboard motor,
always follow the carburetor drain
procedure on page 126.
Close the fuel cap vent knob (refer
to page 42).
Disconnect the fuel coupling from
the outboard motor (refer to page
54).
Trailering
When trailering or transporting the
bot with the motor attached, it-is
recommended that the motor remain
in the normal run position.
(Tiller Handle Type)
Tighten the steering friction adjuster
securely to stop the motorls side to
side movement.
(Remote Control Type)
Use a motor support bar (refer to your
motor support bar manufacturer’s
instructions) to stop the motor’s side-
to-side movement.
If there is insufficient road clearance
with the motor in the normal run
position, then trailer the motor in the
tilted position using a motor support
bar (refer to your motor support bar
manufacrurer’s instructions) or
remove the motor from the boat.
99
To Next Page
Loading...
Need help?
General
