6. OPERATION (REMOTE CONTROL TYPE)
Cruising
LEFT MOTOR
SINGLE TYPE
TRIM/TILT SWITCH
RIGHT MOTOR
TRIM/TILT SWITCH
POWER
TRIMlTILT
SWITCH
DUAL TYPE
POWER
%ZLT
1.
Press
the DN portion of the power
trim/tilt switch to tilt the motor to
the lowest position.
LOWEST
POSITION
If your boat is dual outboard motor
type, adjust the trim angle of the right
and left motors to be equal using the
switches on the control box, as
necessary.
2. Move the control lever
approximately 35” from N (neutral)
toward F (forward) to engage the
F (forward) gear.
N
F
(neutral)
(forward)
I
I
.-----------
MAXIMUM
OPENING
Moving the control lever farther
than 35” will increase the throttle
opening and boat speed.
3. For optimum fuel economy, limit
throttle opening to 80%.
When cruising at high throttle under
rough water condition or large waves,
the propeller may not remain fully in
the water, and the engine speed could
exceed the maximum speed range.
Slow down to keep the propeller in
the water.
83
To Next Page
Loading...
Need help?
General
