Honda Outboard Motor BF75A User Manual

4. PRE-OPERATION CHECKS
Engine Cover Lock Lever Adjustment
If the engine cover becomes loose, it
will shake and become noisy, and it
may allow water to enter.
Inspect the engine cover fastening
condition and adjust if necessary.
Inspection
1. Install the engine cover and fasten
with the front and rear lock levers
turned to LOCK position.
2. Inspect the clearance between the
engine cover and the undercase at
the points as shown.
The clearance should be within
0.19-0.23 in (4.8-5.8 mm).
Inspect front and rear end individually.
FRONT
I
I
INSPECTION POINT
\
REAR
0
i \
1 0.19- 0.23 in
? (4.;- 5.8 mm)
3. Adjust if the clerance is outside the
specified range.
Adjustm.ent
1. Remove the engine cover.
Loosen each hook bracket retaining
bolt and adjust the height of the
brackets to gain the proper clearance.
Adjust front and rear end
individually.
HOOK BRACKET
RETAINING BOLT
51

Honda Outboard Motor BF75A Specifications

General

Brand	Honda
Model	Outboard Motor BF75A
Category	Outboard Motor
Language	English