XNX Universal Transmitter
Section 3 - Calibration
115
Note: Calibrated mA output is required for proper operation of internal diagnostics.
An F165 fault will be reported if the 4-20 mA calibration fails.
Align Excel (Searchline Excel)
Figure 221. Align Excel Menu
For detailed information on aligning the Searchline Excel, see
the Searchline Excel Technical Manual (Honeywell part number
2104M0506).
Alignment Bargraph
Signal Strength
1.00 Signal Strength Target
Reference Value
Figure 222. Align Excel Screen
Align the unit using the information found in the Searchline Excel
manual. As the alignment is performed, the transmitter display will
indicate the signal strength in the form of a bar graph. Align the
Excel until the signal strength bar graph reaches or exceeds 1.00 as
shown on the display.
Soft Reset
(Searchline Excel and Searchpoint Optima Plus only)
Figure 223. Soft Reset Menu
For transmitters connected to a Searchline Excel or Searchpoint
Optima Plus sensor, the Soft Reset sends these infrared devices a
signal to restart the sensor.
Figure 224. Soft Reset Sensor Screen
To Next Page
Loading...
Need help?
General
