Configuration
Under Actions click Configure to access the configuration tasks which include the following:
• Controller settings—Configures the supported controller settings. Depending on the controller,
these can include setting the array accelerator cache ratio, transform and rebuild priorities,
and surface scan delay.
• Caching settings—Configures the supported caching settings which can help increase
performance by taking advantage of cache memory. Caching also helps protect data integrity
when used with a battery or capacitor.
• Clear configuration—Resets the controller's configuration to its default state. Existing arrays
or logical drives are deleted, and data on the logical drives is lost. Confirm this is the preferred
action before proceeding.
• Physical drive write cache settings—Enables or disables the write cache on physical drives
attached to a controller. This feature can improve performance but precautions must be taken
to ensure data integrity.
• Modify spare activation mode—Switches the spare activation mode from the default behavior
(activate on failure only) to predictive spare activation and back.
• Set Bootable Logical Drive/Volume—Sets the primary and secondary boot logical drives and
volumes. Local logical drives as well as remote logical drives and volumes are listed for
selection.
• Manage License Keys—Enables the user to add or remove license keys. Depending on the
keys entered or removed, various features can be enabled or disabled.
• More information — Provides an in-depth display of available information for the currently
selected device and all of its child devices, when applicable.
Diagnostics/SmartSSD
Under Actions click Diagnose to access the diagnostic reporting tools.
Using HP Smart Storage Administrator (HP SSA) 45
To Next Page
Loading...
Need help?
General