10 SERVICE SCHEDULE 33
10.1 Service schedule
Every 30 operating hours/after every race
Every 15 operating hours
Once after 1 operating hour
Read out the fault memory using the Husqvarna Motorcycles diagnostics tool. ○ ● ●
Check that the electrical equipment is functioning properly. ○ ● ●
Check and charge the battery. ● ●
Check the front brake linings. ( p. 70) ● ●
Check the rear brake linings. ( p. 75) ● ●
Check the brake discs. ( p. 69) ● ●
Check the brake lines for damage and leakage. ● ●
Check the rear brake fluid level. ( p. 73) ● ●
Check the free travel of the foot brake lever. ( p. 72) ● ●
Check the frame and swingarm. ● ●
Check the swingarm bearing. ●
Check the heim joints at the top of the shock absorber. ● ●
Check the shock absorber linkage. ● ●
Check the tire condition. ( p. 79) ○ ● ●
Check the tire air pressure. ( p. 80) ○ ● ●
Check the wheel bearing for play. ● ●
Check the wheel hubs. ● ●
Check the rim run-out. ○ ● ●
Check the spoke tension. ( p. 80) ○ ● ●
Check the chain, rear sprocket, engine sprocket and chain guide. ( p. 63) ● ●
Check the chain tension. ( p. 62) ○ ● ●
Grease all moving parts (e.g., side stand, hand lever, chain, ...) and check for smooth operation. ● ●
Check/rectify the fluid level of the hydraulic clutch. ( p. 66) ● ●
Check the front brake fluid level. ( p. 69) ● ●
Check the free travel of the hand brake lever. ( p. 68) ● ●
Check the steering head bearing play. ( p. 47) ○ ● ●
Check the valve clearance. ○ ●
Check the clutch. ●
Change the engine oil and oil filter and clean the oil screens. ( p. 97) ○ ● ●
Check all hoses (e. g., fuel, cooling, bleeding, drainage) and sleeves for cracking, leaks, and incorrect routing. ○ ● ●
Check the antifreeze and coolant level. ( p. 90) ○ ● ●
Check the cables for damage and routing without sharp bends. ● ●
Check that the cables are undamaged, routed without sharp bends and set correctly. ○ ● ●
Clean the air filter and air filter box. ● ●
Change the glass fiber yarn filling of the main silencer. ( p. 57) ●
Check the screws and nuts for tightness. ○ ● ●
Check the headlight setting. ( p. 88) ○ ● ●
Change fuel screen. ( p. 96) ○ ● ●
Check the fuel pressure. ● ●
Adjust the idle speed. ( p. 94) ○ ● ●
Check that the radiator fan is functioning properly. ○ ● ●
Final check: Check the vehicle for roadworthiness and take a test ride. ○ ● ●
Read out the fault memory after the test ride using the Husqvarna Motorcycles diagnostics tool. ○ ● ●
Make the service entry in the Husqvarna Motorcycles Dealer.net and in the Service and Warranty Booklet. ○ ● ●
○ One-time interval
To Next Page
Loading...
Need help?
General
