12 SERVICE WORK ON THE CHASSIS 65
12.41 Checking the frame
401799-01
– Check the frame for cracks and deformation.
» If the frame exhibits cracks or deformation due to a mechanical impact:
– Change the frame.
Info
Always replace a frame that has been damaged due to a mechan-
ical impact. Repair of the frame is not authorized by Husqvarna
Motorcycles.
12.42 Checking the swingarm
401520-01
– Check the swingarm for damage, cracking, and deformation.
» If the swingarm shows signs of damage, cracking, or deformation:
– Change the swingarm.
Info
Always change a damaged swingarm. Repair of the swingarm is
not authorized by Husqvarna Motorcycles.
12.43 Checking the routing of the throttle cable
Preparatory work
– Remove the seat. ( p. 49)
– Remove the fuel tank. ( p. 59)
H00227-01
Main work
– Check the throttle cable routing.
Both throttle cables must be routed to the throttle valve body side by side
behind the handlebars and above the fuel tank bearing.
» If the throttle cable is not routed as specified:
– Correct the throttle cable routing.
Finishing work
– Install the fuel tank. ( p. 60)
– Mount the seat. ( p. 50)
To Next Page
Loading...
Need help?
General
