12 SERVICE WORK ON THE CHASSIS 58
M00434-10
(FE US)
–
Remove screws
of connecting cap
.
–
Remove the connecting cap with the perforated pipe, O-ring
, and glass
fiber yarn filling
.
–
Remove screws
and silencer cap
with O-ring
.
–
Remove screws
and insert
together with insulating pad
.
– Remove the insulating pad from the insert.
– Clean the parts that need to be reinstalled and check for damage.
– Mount the new insulating pad on the insert and fasten with adhesive tape.
–
Position the insert with the insulating pad in outer tube
.
–
Mount and tighten screws
.
Guideline
Screws on the main silencer M5 7 Nm (5.2 lbf ft)
–
Mount O-ring
on the silencer cap.
– Mount new glass fiber yarn filling on the perforated pipe.
– Mount the connecting cap with the glass fiber yarn filling in the outer tube.
Info
Press the glass fiber yarn filling into the outer tube using a blunt tool.
–
Mount and tighten screws
.
Guideline
Screws on the main silencer M5 7 Nm (5.2 lbf ft)
–
Mount O-ring
on the silencer cap.
–
Position the silencer cap with O-ring
in the outer tube.
–
Mount and tighten screws
.
Guideline
Screws on the main silencer M5 7 Nm (5.2 lbf ft)
Finishing work
– Install the main silencer. ( p. 57)
– Install the right side cover. ( p. 58)
12.32 Removing the right side cover
S00902-10
–
Remove screw
.
–
Pull off the side cover in area
sideways and remove it toward the rear.
12.33 Installing the right side cover
S00902-10
–
Position the side cover and engage in area
.
–
Mount and tighten screw
.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
To Next Page
Loading...
Need help?
General
