Hypertherm Powermax45 XP User Manual

Installation and Setup
1
Powermax45 XP Operator Manual 809240 21
What to do if components are missing or damaged
 Claims for damage during shipment
 File a claim with the carrier if your system was damaged during shipment.
 Obtain the system’s model number and serial number, located on the bottom of the
plasma power supply.
 Obtain a copy of the bill of lading from Hypertherm.
 Claims for missing or damaged merchandise
 Contact your Hypertherm distributor if any component is missing or damaged.
If you need additional assistance, call the nearest Hypertherm office listed in the front of this manual.
Hypertherm plasma power supply ratings
Rated open-circuit voltage (U
0
) 200 – 240 V, CSA/CE/CCC
400 V, CE/CCC
480 V, CSA
275 VDC
265 VDC
275 VDC
Output characteristic* Drooping
Rated output current (I
2
) 10A–45A
Rated output voltage (U
2
) 145 VDC
Duty cycle at 40°C (104°F)
†
50% at 45 A (I
2
) / 145 VDC (U
2
)
60% at 41 A (I
2
) / 145 VDC (U
2
)
100% at 32 A (I
2
) / 145 VDC (U
2
)
Operating temperature -10°C – 40°C (14°F – 104°F)
Storage temperature -25°C – 55° C (-13°F – 131°F)
Power factor 200 – 240 V, 1-phase, CSA/CE/CCC
400 V, 3-phase, CE/CCC
480 V, 3-phase, CSA
0.99
0.94
0.93
R
sce
– Short Circuit Ratio
(CE systems only)
U
1
– Volts AC rms, 3-phase
400 V CE
R
sce
250
EMC emissions classification
CISPR 11 (CE models only)
‡
Class A
Input voltage (U
1
) / Input current (I
1
)
at rated output (U
2MAX
I
2MAX
)
(See Voltage configurations on
page 28.)
200 – 240 V CSA
230 V CE/CCC**,
††
400 V CE/CCC**,
‡‡
480 V CSA
200 – 240 V, 1-phase, 50/60 Hz, 39 – 32 A
230 V, 1-phase, 50/60 Hz, 33 A
400 V, 3-phase, 50/60 Hz, 11 A
480 V, 3-phase, 50/60 Hz, 9.4 A
Gas type Air Nitrogen (N
2
) F5*** Argon
†††
ARC WELDING SUPPLIES - 07 847 7870

Hypertherm Powermax45 XP Specifications

General

Brand	Hypertherm
Model	Powermax45 XP
Category	Welding System
Language	English