Hypertherm Powermax45 XP User Manual

Installation and Setup
1
22 809240 Operator Manual Powermax45 XP
Cutting specifications
Recommended cut capacity – handheld
Pierce capacity
Gas quality Clean, dry,
oil-free per
ISO 8573-1
Class 1.2.2
99.95% pure
Clean, dry,
oil-free
99.98% pure
(F5 = 95%
nitrogen [N
2
], 5%
hydrogen [H])
99.99% pure
Clean, dry,
oil-free
Recommended gas inlet
flow rate/pressure
Cutting 188.8 L/min at 5.9 bar (400 scfh at 85 psi)
Maximum control gouging 165.2 L/min at 4.1 bar (350 scfh at 60 psi)
Precision gouging, marking 165.2 L/min at 3.8 bar (350 scfh at 55 psi)
* Defined as a plot of output voltage versus output current.
†
See the data plate on the bottom of the power supply for more information on duty cycle and for IEC ratings.
‡
WARNING: This Class A equipment is not intended for use in residential locations where the electrical power is
provided by the public low voltage supply system. There may be potential difficulties in delivering electromagnetic
compatibility in those locations, due to conducted as well as radiated disturbances.
** This product meets the technical requirements of IEC 61000-3-3 and is not subject to conditional connection.
††
Equipment complies with IEC 61000-3-12.
‡‡
Equipment complies with IEC 61000-3-12 provided that the short-circuit power S
sc
is greater than or equal to
1911 KVA at the interface point between the user’s supply and the public system. It is the responsibility of the
installer or user of the equipment to ensure, by consultation with the distribution network operator if necessary, that
the equipment is connected only to a supply with a short-circuit power S
sc
greater than or equal to 1911 KVA.
*** F5 recommended only for cutting stainless steel. See page 111.
†††
Argon recommended only for marking applications at 10 – 25 A. See page 113.
Cut speed Material thickness
500 mm/min (20 inches per minute [in/min])* 16 mm (5/8 inch)
250 mm/min (10 in/min)* 22 mm (7/8 inch)
125 mm/min (5 in/min)* – severance capacity 29 mm (1-1/8 inch)
* Cut capacity speeds are not necessarily maximum speeds. They are the speeds that must be achieved to
be rated at that thickness.
Torch type Material thickness
Handheld 12 mm (1/2 inch)
Mechanized with a programmable torch height control 12 mm (1/2 inch)
ARC WELDING SUPPLIES - 07 847 7870

Hypertherm Powermax45 XP Specifications

General

Brand	Hypertherm
Model	Powermax45 XP
Category	Welding System
Language	English