Hypertherm Powermax45 XP User Manual

Set Up the Machine Torch
5
90 809240 Operator Manual Powermax45 XP
Disassemble the machine torch
Use the following procedure if you need to disassemble the torch to route the torch through the
cutting table’s track or other mounting system.

While disconnecting and reconnecting the torch parts, do not twist the
torch or the lead. Maintain the same orientation between the torch head
and torch lead. Twisting the torch head in relation to the torch lead can
damage the torch wires.
1. Disconnect the torch from the plasma power supply.
2. Remove the consumables from the torch.
3. Place the torch on a flat surface with the left side of the shell facing up.

The left side of the shell is the side with the screws.
4. Remove the 7 screws from the torch shell. Set the screws aside.
5. Carefully pry the left side of the shell away from the torch.
ARC WELDING SUPPLIES - 07 847 7870

Hypertherm Powermax45 XP Specifications

General

Brand	Hypertherm
Model	Powermax45 XP
Category	Welding System
Language	English