Hypertherm Powermax45 XP User Manual

Gouge with the Hand Torch and Machine Torch
4
Powermax45 XP Operator Manual 809240 75
Gouge with the hand torch
1. Install the Maximum Control gouging consumables or the Precision gouging consumables.
2. Set the system to Gouge/Marking mode. See page 51.
3. Set the output current to match the consumables installed:
 Maximum Control gouging consumables: 26 – 45 A
 Precision gouging consumables: 10 – 25 A
4. Hold the torch at approximately a 40° angle to the workpiece before firing the torch.
 Maximum Control gouging consumables: Hold the torch approximately 6 mm (1/4 inch)
above the workpiece.
 Precision gouging consumables: Hold the torch approximately 2 – 3 mm above the
workpiece.
Press the trigger to obtain a pilot arc. Transfer the arc to the workpiece.
5. Stretch the arc as follows:
 Maximum Control gouging consumables: 19 – 25 mm (3/4 – 1 inch)
 Precision gouging consumables: 10 – 11 mm (3/8 – 1/2 inch)
WARNING!
SPARKS AND HOT METAL CAN INJURE EYES AND BURN SKIN
When firing the torch at an angle, sparks and hot metal will spray out from the
nozzle. Point the torch away from yourself and others. Always wear proper protective
equipment including gloves and eye protection.
40°
ARC WELDING SUPPLIES - 07 847 7870

Hypertherm Powermax45 XP Specifications

General

Brand	Hypertherm
Model	Powermax45 XP
Category	Welding System
Language	English