d. Squeeze the clip on the side of the battery and battery carrier to remove the
battery from the battery carrier.
Note: If your battery and battery carrier are attached with screws instead of
a locking-clip mechanism, remove the three screws to remove the battery
from the battery carrier.
e. If you are instructed to return the ServeRAID SAS controller battery, follow
all packaging instructions, and use any packaging materials for shipping that
are supplied to you.
Installing a ServeRAID SAS controller battery on the remote battery
tray
To install a ServeRAID SAS controller battery on the remote battery tray, complete
the following steps:
1. Install the replacement battery on the remote battery tray:
a. Place the replacement battery on the battery carrier from which the former
battery had been removed, and connect the battery carrier cable to the
replacement battery.
b. Connect the remote battery cable to the interposer card.
Attention: To avoid damage to the hardware, make sure that you align the
black dot on the cable connector with the black dot on the connector on the
interposer card. Do not force the remote battery cable into the connector.
208 IBM System x3650 M3 Types 4255, 7945, and 7949: Problem Determination and Service Guide
To Next Page
Loading...
Need help?
General