IBM System x3650 M3 4255 Service Guide

Removing the operator information panel assembly
To remove the operator information panel assembly, complete the following steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 169.
2. Remove the cover (see “Removing the cover” on page 177).
3. Disconnect the cable from the back of the operator information panel assembly.
4. Reach inside the server and press the release tab; then, while you hold the
release tab down, push the assembly toward the front of the server.
5. From the front of the server, carefully pull the operator information panel
assembly out of the server.
6. If you are instructed to return the operator information panel assembly, follow all
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
Installing the operator information panel assembly
To install the replacement operator information panel assembly, complete the
following steps.
1. Position the operator information panel assembly so that the tabs face upward
and slide it into the server until it clicks into place.
2. Inside the server, connect the cable to the rear of the operator information panel
assembly.
3. Install the cover (see “Installing the cover” on page 178).
4. Slide the server into the rack.
Chapter 5. Removing and replacing server components 233

IBM System x3650 M3 4255 Specifications

General

Brand	IBM
Model	System x3650 M3 4255
Category	Server
Language	English