EasyManuals Logo
Home>Icom>Transceiver>IC-M802

Icom IC-M802 Instruction Manual

Icom IC-M802
78 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
2
2
PANEL DESCRIPTION
2001 NEW
Front panel— Controller
q DISTRESS SWITCH [DISTRESS] (p. 18)
Push for 5 sec. (approx.) to make a distress call.
w DSC SWITCH [DSC]
Switches DSC watch mode and voice/e-mail com-
munication mode when pushed.
e CANCEL/CALL SWITCH [CANCEL/CALL]
Cancels a distress or DSC repeat call. (p. 20)
Push for 1 sec. to start calling after DSC contents
are setup.
r HEADPHONE JACK [ ]
Accepts headphones.
Output power: 5 mW with a 16 load (stereo).
t MICROPHONE CONNECTOR [MIC]
Accepts the supplied or optional microphone.
See p. 66 for appropriate microphones.
See p. 61 for microphone connector information.
y GROUP SELECTOR [GRP]
Selects groups in 20 channel steps and ITU ma-
rine channel groups.
(p. 8)
Selects items during quick/initial set mode, etc.
u CHANNEL SELECTOR [CH]
Selects an operating channel within the selected
channel group such as ITU channels. (p. 8)
User channels can be selected from 1 to 160 (max.)
in sequence regardless of the channel group.
Changes setting or value of the selected item
during quick/initial set mode, etc.
i RX/CLARITY SWITCH [RX
CLAR
]
After pushing [F], turns the clarity function ON
and OFF. (p. 12)
[CH] is used for clarity control.
During DSC watch mode, enters RX memory se-
lect screen. (p. 38)
[CH] is used for distress and other call selection.
o POWER SWITCH [POWER]
Push to turn the power ON.
Push for 1 sec. to turn the power OFF.
!0 TX/TRANSMIT FREQUENCY SWITCH [TX
TXF
]
After pushing [F], displays the transmit fre-
quency, and opens the squelch. Checks and mon-
itors the transmit frequency while holding. (p. 10)
During DSC watch mode, enters TX memory se-
lect screen. (p. 43)
[CH] is used for memory selection.
!1 VOLUME CONTROL [VOL]
Adjusts the audio output level.
Audio does not come from the speaker when:
- The speaker switch is turned ON.
- The squelch function is turned ON and no signal is
being received.
- During DSC watch mode.
DISTRESS
q
w
e
r
t
yuio!0 !1
!2
!3
!4!5!6!7Function display (pgs. 6, 7)
IC-M802_USA.qxd 02.5.30 11:39 Page 2

Table of Contents

Other manuals for Icom IC-M802

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Icom IC-M802 and is the answer not in the manual?

Icom IC-M802 Specifications

General IconGeneral
BrandIcom
ModelIC-M802
CategoryTransceiver
LanguageEnglish

Related product manuals