Icom IC-M802 Instruction Manual

6
15
DSC PREPARATION
2001 NEW
5
6
■ MMSI code programming
The 9-digit MMSI (Maritime Mobile Service Identity:
DSC self ID) code can be programmed.
This operation is not necessary when the MMSI
code has been programmed by your dealer. How-
ever, the code re-programming can be performed 2
times only. This code is displayed when the power is
turned ON.
DD
Programming
q While pushing [F] and [DSC], push [POWER] to
turn the power ON.
w Push [DSC] to select DSC watch mode.
e Push [MODE SET
].
• DSC menu is selected as follows.
r Rotate [CH] to select “Set up,” then push [ENT].
t Rotate [CH] to select “MMSI Code,” then push
[ENT].
y Enter the specified 9-digit MMSI code via the key-
pad.
• Make sure the correct code is entered.
• Rotate [CH] to move the cursor.
u Push [ENT] to program the code.
•After pushing [ENT], return to the display as described
in step t.
i Push [MODE SET ] to exit the DSC menu.
RX
J3E
GPS
12.345.0
Exit
SP
Lat
34 34'N
Lon135
34'E
12:34
******** Set up ********
------
MMSI check ------
ID:
123456789
Cancel OK
******** Set up ********
------
MMSI check ------
ID:
† ________
Cancel OK
******** Set up ********
--------
Select --------
Address
ID
Group
ID
Call
frequency
Traffic
frequency
Scan
frqeuency
MMSI
check
Ç
OKSEL
******* DSC MENU *******
--------
Select --------
Position
RX
memory
Set
up
Exit
Ç
OKSEL
[MODE SET][ENT][DSC]
[F][CH] [POWER]
IC-M802_USA.qxd 02.5.30 11:39 Page 15

Icom IC-M802 Specifications

General

Brand	Icom
Model	IC-M802
Category	Transceiver
Language	English