16
6
DSC PREPARATION
2001 NEW
■ Position and time programming
q While pushing and holding [MODE
SET
] push
[POWER] to enter initial set mode.
• Turn the power OFF in advance.
w Rotate [GRP] to select the “GPS DISPLAY” then
rotate [CH] to select the desired position indication
type from simple and detail.
e Rotate [GRP] to select the “OFFSET TIME” then
rotate [CH] to set the time difference between local
and the UTC times within –12 to +12 hours in
10 minute steps.
r Turn the power OFF once, then ON again to exit
quick set mode.
✔ When a position and the UTC time data
(NMEA0183 ver. 3.01 format) is applied to [GPS],
the following steps are not necessary.
t Push [DSC] to select DSC watch mode.
y Push [MODE
SET
] to enter the DSC menu.
• DSC menu is displayed as below.
u Rotate [CH] to select “Position,” then push
[ENT].
i Enter your position and the UTC time via the key-
pad, then push [ENT]
•Push [3
SCAN
] for the ‘East,’ [9
H
i] for the ‘West,’ [6
RF
-
G
]
for the ‘North’ and [7
L
o] for the ‘South’ setting.
•Degrees and minutes digits can only be entered even
when “DETAIL” is selected for the position indication
in step w— the seconds digits show “0” only.
• Rotate [CH] to move the cursor.
o Push [ENT] to program the position and time.
• Return to the “DSC MENU” indication as in step u.
!0 Push [MODE
SET
] to exit the DSC menu.
•Rotate [CH] to select “Exit” then push [ENT] also
exits set mode.
•“MNL” appears instead of “GPS.”
*******
Position
*******
---
Position
&
time
----
Latitude
Longitude
UTC
34
34'N
135
34'E
12:34
OKNull
*******
DSC
MENU
*******
--------
Select
--------
Position
Individual
Group
All
ships
Position
REQ
Distress
Ç
OKSEL
***
SET
MODE
***
SIMPLE
DETAIL
ÇÇ
ITEM SEL
When no position and the UTC (Universal Time Coor-
dinated) time data in NMEA0183 ver. 3.01 format, such
as from a GPS receiver, etc., is applied to [GPS] con-
nector, your position and the UTC time should be input
for DSC operation.
IMPORTANT!
The manually programmed position and the UTC
time settings will be cleared once the power is
turned OFF. They are never renewed during the
voyage when the position is set manually.
RX
J3E
MNL
12.345.0
Exit
SP
34
34.000N
135
34.000E
12:34
RX
J3E
MNL
12.345.0
Exit
SP
Lat
34
34'N
Lon135
34'E
12:34
• Simple position indication • Detail position indication
IC-M802_USA.qxd 02.5.30 11:39 Page 16
To Next Page
Loading...
Need help?
General
