Icom IC-M802 Instruction Manual

49
12
SET MODE
12
■ Initial set mode
Initial set mode operation is used for programming in-
frequently changed values, conditions or functions.
DD
Entering set mode
q Turn the power OFF, if the transceiver is powered
ON.
w While pushing [MODE SET ], push [POWER] to turn
the power ON to enter initial set mode.
e Rotate [GRP] to select the desired item.
e Rotate [CH] to set the values or conditions for the
selected item.
rTurn the power OFF and ON again to exit set mode.
DD
Initial set mode items
NOTE: Selection of some of the set mode items de-
scribed here are not available on some transceiver
versions.
[POWER][MODE SET]
Number of user channels
This item sets the number of user channels. Up to
160 channels can be set. (default: 160)
*** SET MODE ***
ITEM SEL
FSK ITU channel selection
This item sets the capability of the ITU channels for
FSK from ON and OFF.
This item will not appear when ITU channels are in-
hibited. (default: OFF)
*** SET MODE ***
ITEM SEL
OFF
ON
ÇÇ
External antenna tuner type
This item selects the connected Icom antenna tuner
type from AT-140, AT-130/E, AT-120/E and AH-3
• AT-140 : AT-140 is connected. (default)
• AT-130/E : AT-130/E is connected.
• AT-120/E : AT-120/E is connected.
• AH-3 : AH-3 is connected.
*** SET MODE ***
AT-140
AT-130/E
AT-120/E
AH-3
ÇÇ
ITEM SEL
Automatic tune
When an optional automatic antenna tuner is con-
nected, tuning can be started automatically without
pushing [TUNE THRU ], for instant operation.
If manual tuning is required, this automatic operation
can be deactivated.
(default: OFF)
*** SET MODE ***
OFF
ON
ÇÇ
ITEM SEL
IC-M802_USA.qxd 02.5.30 11:40 Page 49

Icom IC-M802 Specifications

General

Brand	Icom
Model	IC-M802
Category	Transceiver
Language	English