Manual Page 17
A.5 Device Location
Please allow a minimum of 150 mm (6 inch) from any side walls and 300 mm (12 inch)
from a back wall. Leave one meter (3 feet) minimum distance from any door or entrance
way. Use the illustration below as a guide.
Picture 1: Minimum distances
Do not operate the scanner in an area that has poor air circulation and/or that is non-
ventilated.
Place the WideTEK 25 on a flat and solid base. The load bearing capacity of the base
must correspond to the device weight.
Placing the WideTEK 25 on the optional floor stand is recommended for the best
ergonomic position while using the scanner.
Choose a location that complies with the limits of temperature and humidity. Refer to the
technical specification.
Note: Before using the WideTEK 25 scanner in the new environment allow at least one
hour for temperature adaptation.
Temperature adaptation means:
A fast change from cold to warm environmental conditions can build up
condensation inside the housing. This will result in unfavorable scanned images
and could cause permanent damages to the unit.
To Next Page
Loading...
Need help?
General
