Image Access WideTEK 25 - B.3.5 Output Option Copy

Page 74 Manual
B.3.5 Output Option Copy
This output option prints directly to a previously installed network printer. The Option key
is used to configure the remotely connected printer.
Picture 73: Output Option Copy
B.3.5.1 Remote Printer
Parameter Description
Printer Preset
Choose a printer configuration out of five possible sets of
parameters. If you click on Change Name you can change
the name of this set.
Connection Type
Choose between IP Networking and SMB Printer Queue.
Address
(with IP Networking only)
Enter the IP address of the printer.
Port (9100)
(with IP Networking only)
Enter the IP port of the remote printer. Default is port 9100.
Connection Timeout
(with IP Networking only)
Choose the timeout for connecting to the remote printer
before the connection is aborted.
Port (139)
(with SMB Printer Queue only)
Enter the IP port of the remote printer. Default is port 139.
Server Authentication
(with SMB Printer Queue only)
Select Yes or No
Note: Each change of an entry field is transferred to the scanner immediately.