19www.janome.com
User Manual QUILT MAKER PRO 20
Congurable Handlebar Buons
The Janome QMP 20 handlebars are congurable; you can decide which funcons you want select buons
to operate. Once congured, the front and back handlebars work the same.
The machine comes from Janome congured to have the right handlebar control starng and stopping
quilng, and increasing stching speed in Manual mode or stches per inch in Regulated mode. The le
handlebar controls cycling the needle up and down, and slowing the stching speed or decreasing stches
per inch. However, you can switch the funcons from one side to the other when you set up your machine.
You can also select from several funcons and assign one to the star buon and another to the diamond
buon. For example, choose to have the diamond buon perform a e-o and the star buon perform
another desired funcon.
For more informaon about conguring the handlebars and buons, see To customize the handlebar
buons in the Toolbar Opons secon of this manual.
Install the handlebar labels according to what you want each handlebar to do. For example, if you are
le-handed, you may want the le handlebar to control starng and stopping the stching.
NOTE: The tradional handlebar conguraon has the Start and Stop buons on the right
handlebar and the Needle Up and Down buons on the le handlebar.
To aach labels to the handlebars
U CAUTION: Be absolutely certain of your handlebar label choice before installing the labels.
Once they are stuck down they cannot be removed without damaging the switch.
1. Peel o the paper backing o the labels and place them on the front handlebars according
to how you plan to congure the funcons.
2. Repeat for the oponal rear handlebars, making sure that you match the placement from the
front handlebars.
Cycles the
needle up or
down
Congurable
buon
Starts or stops
stching
Congurable
buon
Increases or
decreases
stching
speed
(Manual
mode)
Increases or
decreases
stches
per inch
(Regulated
mode)