Janome Quilt Maker Pro 20 User Manual

23www.janome.com
User Manual QUILT MAKER PRO 20
Thread Tray and Thread Mast
To install the thread tray on the machine
1. Locate the two small M4x10mm hex buon head screws and the thread mast assembly.
2. Align the screws in the thread mast bracket with
the two holes in the side of the machine (top
tension side). Use a 2.5mm hex tool to ghten
the bracket rmly to the side of the machine.
Optional Accessories
QMP 20 Ruler Base
If you plan to use rulers and templates with the QMP 20, you will need to purchase the ruler base to give
you a large, stable surface on which to rest the ruler or template. The ruler base and rulers and templates
are oponal accessories. For more informaon, visit hp://www.Janome.com.
To install the ruler base
1. The QMP 20 machine comes with four
preinstalled mounts for the ruler base.
2. With the Ruler Base lted down about 30°,
align the back ruler-base hooks with the
machine mounts unl they are about to catch,
then lower the front of the ruler base unl the
front hooks align and catch, also. With all four
ruler-base hooks aligned and started onto the
machine mounts, push the ruler base back into
the nal posion.
To remove the ruler base
• Grasp the front corners of the ruler base, pull
the ruler base towards you and then up on an angle
o the machine.

Janome Quilt Maker Pro 20 Specifications

General

Brand	Janome
Model	Quilt Maker Pro 20
Category	Sewing Machine
Language	English