Janome Quilt Maker Pro 20 User Manual

31www.janome.com
User Manual QUILT MAKER PRO 20
Bobbin and Bobbin Tension
The QMP 20 quilng machine uses M-class bobbins that are larger than home sewing machine L-class
bobbins. The larger bobbins hold more thread and enable you to quilt for a longer me between
bobbin changes.
The QMP 20 also has a low-bobbin alarm. For more informaon about the low-bobbin alarm, see
To congure the low-bobbin alarm sengs in the Toolbar Opons secon of this manual.
To wind the bobbin
The QMP 20 comes with a separate bobbin winder. For full instrucons about using the bobbin winder, see
the instrucon manual that is packaged with the bobbin winder.
To insert the bobbin into the bobbin case
U CAUTION: To prevent personal injury, always turn o the front power switch while inserng
and/or removing the bobbin case or anyme your hands are near the needle area, such as
when you change the needle.
1. Place the bobbin in the bobbin case so that the
thread pulls o clockwise when viewing the
open side.
2. Slide the thread through the slot and under the
tension spring, leaving approximately ve to six
inches of thread hanging loose.
To test bobbin tension
The bobbin tension is the foundaon for stch tension. Always set the bobbin tension rst.
 NOTE: Check the bobbin tension each me a new bobbin is inserted.
1. With the bobbin properly in the bobbin case, hold the bobbin case in the palm of your hand with the
open end facing up.

Janome Quilt Maker Pro 20 Specifications

General

Brand	Janome
Model	Quilt Maker Pro 20
Category	Sewing Machine
Language	English