JUKI IT-100 User Manual

– 35 –
1
1
4-5. Needle up/down compensation switch
4-4. Re-sewing switch
The re-sewing switch is used when the bobbin thread runs out during the programmed stitching pattern sew-
ing steps or the like.
To r etur n to the fi rst ste p of the pr o-
grammed stitching pattern without using
re-sewing switch
1
, depress the back part
of the pedal to actuate the thread trimmer.
This makes the operation panel give the
step indication 1. Now, you can start sew-
ing from the first step of the programmed
stitching pattern.
1) The bobbin thread runs out during the operations
steps for sewing.
a
2) Bring the pedal to its neutral position to make the
sewing machine stop. Now, depress the back part
of the pedal to make the thread trimmer actuate.
b
3) Turn ON re-sewing switch
1
.
c
4) Replace the bobbin. Slightly feed the material on
the machine in the reverse direction to return the
material to the position where the sewing was inter-
rupted to allow the sewing machine to sew over the
nished seam in step 2.
d
5) Depress the front part of the pedal until stop posi-
tion
e
of step 2 is reached.
6) Turn ON re-sewing switch
e
again at position
1
where the sewing has been interrupted, and the next
step will be indicated on the operation panel. Now,
you can re-start sewing of the programmed stitching
pattern.
* If the needle thread breaks or any other trouble oc-
curs, which is caused by re-sewing switch
1
dur-
ing the operation steps (
d
→
e
) in the free sewing
mode, bring the pedal to its neutral position, Then
depress the back part of the pedal to actuate the
thread trimmer. Thread the machine head and slightly
feed the material in the reverse direction, and press
re-sewing switch
1
. This enables the sewing machine
to continue the sewing under the free sewing mode.
Then operate the operation panel as described in the
aforementioned steps 5) and 6).
Step 4
D
C
B
A
Step 3Step 1
d
e
a
b
c
Every time needle up/down compensation switch
1
is
pressed, the needle goes up when it is in its lowest position
or comes down when it is in its highest position. This compen-
sates the stitch by a half of the predetermined stitch length.
Note, however, that the machine does not run continuously at
a low speed even if you keep the switch held pressed.
Also, note that the needle up/down compensation switch is in-
operative after turning the handwheel by hand.
Thread trimming is operative only at the time of stitch compensa-
tion after depressing the front part of the pedal once.

JUKI IT-100 Specifications

General

Brand	JUKI
Model	IT-100
Category	Sewing Machine
Language	English