•
CAT5e or CAT6 Ethernet Cable of appropriate length
•
Mounting bracket for wall-mounting or overhead-mounting the access point
•
Overhead enclosure for overhead-mounting the access point
•
Screws or wall anchors for wall-mounting the access point
•
Screwdriver or wrench appropriate for the wall-mounting screws or anchors
Related
Documentation
Site Preparation Checklist for the AX411 Access Point on page 15•
• General Site Guidelines for Installing the AX411 Access Point on page 17
• AX411 Access Point Setup Overview on page 18
AX411 Access Point Setup Overview
After you have prepared your installation site, you are ready to unpack and install the
AX411 Access Point. It is important to proceed through the installation process as described
in Table 10 on page 18.
When you install the access point as described in Table 10 on page 18, the services
gateway loads a default configuration onto the access point, which establishes basic
WLAN parameters.
After you have set up the access point and established basic WLAN connectivity, see the
Junos OS WLAN Configuration and Administration Guide and Junos OS CLI Reference for
information on performing advanced WLAN configuration.
Table 10: Installation Process Order for the AX411 Access Point
For More InformationTaskStep
“AX411 Access Point General Safety Guidelines and Warnings”
on page 63
Review the safety guidelines.1
“Site Preparation Checklist for the AX411 Access Point” on
page 15
Verify that you have prepared your site for the
installation of the access point using the checklist.
2
“Unpacking the AX411 Access Point” on page 21
“Verifying Parts Received with the AX411 Access Point” on
page 21
Unpack the access point and verify that all parts
are present.
3
“Installing the AX411 Access Point on a Flat Surface” on page 23
“Installing the AX411 Access Point on a Wall” on page 23
“Installing the AX411 Access Point in an Overhead Enclosure”
on page 25
Install the access point.4
Copyright © 2012, Juniper Networks, Inc.18
AX411 Access Point Hardware Guide