Jupiter AX411 Access Point User Manual

• Connecting the AX411 Access Point to the SRX Series Device on page 33
• Providing Power to the AX411 Access Point Using Power over Ethernet on page 33
Powering On and Powering Off the AX411 Access point
The access point does not have a dedicated power switch. The access point is powered
on whenever either of the following two conditions is met:
•
The access point is receiving power from an Ethernet connection configured for Power
over Ethernet (PoE)
•
The access point is connected to the optional power supply
To power on the access point:
1. Do one of the following:
•
Connect the access point Ethernet port to an Ethernet connection configured for
PoE.
•
Connect the Power connector on the front panel of the access point to the optional
power supply.
2. Check that the Power LED on the top of the access point lights steadily green.
To power off the access point:
1. Do one of the following:
•
If the access point is powered by PoE, disconnect the Ethernet cable connected to
the access point Ethernet port.
•
If the access point is powered by the optional power supply, disconnect the power
supply from the Power connector on the access point front panel.
2. Check that the Power LED on the top of the access point is unlit.
Related
Documentation
• AX411 Access Point Connection Overview on page 31
• Providing Power to the AX411 Access Point Using Power over Ethernet on page 33
• Providing Power to the AX411 Access Point Using the Power Supply on page 34
35Copyright © 2012, Juniper Networks, Inc.
Chapter 6: Connecting the AX411 Access Point

Jupiter AX411 Access Point Specifications

General

Brand	Jupiter
Model	AX411 Access Point
Category	Wireless Access Point
Language	English