a radio or television receiver in a domestic environment, it may cause radio interference.
Install and use the equipment according to the instruction manual.
United States
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Related
Documentation
AX411 Access Point Agency Approvals on page 76•
• AX411 Access Point Compliance Statements for Environmental Requirements on
page 78
• AX411 Access Point Compliance Statements for Acoustic Noise on page 79
AX411 Access Point Compliance Statements for Environmental Requirements
This topic includes the compliance statement for the following environmental
requirement:
Lithium Battery
Batteries in this product are not based on mercury, lead, or cadmium substances. The
batteries used in this product are in compliance with EU Directives 91/157/EEC, 93/86/EEC,
and 98/101/EEC. The product documentation includes instructional information about
the proper method of reclamation and recycling.
Related
Documentation
AX411 Access Point Agency Approvals on page 76•
• AX411 Access Point Compliance Statements for EMC Requirements on page 77
• AX411 Access Point Compliance Statements for Acoustic Noise on page 79
Copyright © 2012, Juniper Networks, Inc.78
AX411 Access Point Hardware Guide