Jupiter AX411 Access Point User Manual

Table 9: Site Preparation Checklist for the AX411 Access Point Installation (continued)
NotesDatePerformed ByFor More InformationItem or Task
See the instructions provided
with the overhead enclosure.
Install the enclosure
containing the access
point.
Cables
“Interface Cable and Wire
Specifications for the AX411
Access Point” on page 101
Acquire cables and
connectors.
Review the maximum
distance allowed for
each cable. Choose
the length of cable
based on the distance
between the hardware
components being
connected.
Plan the cable routing
and management.
Related
Documentation
General Site Guidelines for Installing the AX411 Access Point on page 17•
• Tools and Parts Required to Install the AX411 Access Point on page 17
• AX411 Access Point Setup Overview on page 18
General Site Guidelines for Installing the AX411 Access Point
Observe the following general guidelines when installing the AX411 Access Point:
•
To prevent overheating, the airflow around the chassis must be unrestricted. Allow
sufficient clearance between the front and back of the chassis and adjacent equipment.
Ensure that there is adequate circulation in the installation location.
•
Follow the electrostatic discharge (ESD) procedures to avoid damaging equipment.
ESD can cause components to fail completely or intermittently over time.
Related
Documentation
Site Preparation Checklist for the AX411 Access Point on page 15•
• Tools and Parts Required to Install the AX411 Access Point on page 17
• AX411 Access Point Setup Overview on page 18
Tools and Parts Required to Install the AX411 Access Point
You must have the following tools and parts to install the AX411 Access Point:
17Copyright © 2012, Juniper Networks, Inc.
Chapter 3: Installation Overview for the AX411 Access Point

Jupiter AX411 Access Point Specifications

General

Brand	Jupiter
Model	AX411 Access Point
Category	Wireless Access Point
Language	English