Jupiter AX411 Access Point User Manual

CHAPTER 8
Monitoring the AX411 Access Point
This section includes the following topics:
•
Monitoring the AX411 Access Point with the LEDs on page 51
•
Monitoring the AX411 Access Point with the Command-Line Interface on page 52
Monitoring the AX411 Access Point with the LEDs
At regular intervals, check the AX411 Access Point LEDs to make sure that the access
point is functional and has not encountered an error condition.
Under normal operating circumstances, the access point LEDs will be in the condition
shown in Table 15 on page 51.
Table 15: Access Point LED Normal Indications
DescriptionStateColorLED
The access point is powered on and operating
normally.
On steadilyGreenPower
The access point is being managed by the SRX
Series Services Gateway.
On steadilyGreenStatus
The 5 GHz radio is enabled and broadcasting.
This LED will be off if the 5 GHz radio is disabled,
for example, if the radio settings for the country
code do not allow the use of 5 GHz channels.
FlashingBlueRadio 1 (5
GHz radio)
The 2.4 GHz radio is enabled and broadcasting.
This LED will be off if the 2.4GHz radio is disabled,
for example, if the radio settings for the country
code do not allow the use of 2.4 GHz channels.
FlashingGreenRadio 2 (2.4
GHz radio)
Table 16 on page 52 describes the LED indications that occur while the access point is
starting up.
51Copyright © 2012, Juniper Networks, Inc.

Jupiter AX411 Access Point Specifications

General

Brand	Jupiter
Model	AX411 Access Point
Category	Wireless Access Point
Language	English