Jupiter AX411 Access Point User Manual

Installing the Overhead Enclosure Containing the AX411 Access Point
See the instructions provided with the overhead enclosure to install the enclosure at your
site.
Removing the AX411 Access Point Plastic Cover
The decorative plastic cover of the AX411 Access Point does not meet flammability
requirements for installations in environmental airspaces. The space above a suspended
ceiling may constitute an environmental airspace if it is used as a plenum for the building
ventilation system. You must remove the plastic cover whenever you install the access
point in an environmental airspace. You can remove the plastic cover without affecting
the operation or performance of the access point.
To remove the plastic cover:
1. Turn the access point over so that the underside of the device faces upward.
2. Locate the retaining latches at each corner that latch the plastic cover onto the metal
chassis. The latches are shown in Figure 10 on page 28.
Figure 10: Releasing the Plastic Cover
Release latches at one
edge of chassis and lift
metal chassis edge slightly
Release latches at
remaining edge and lift
metal chassis out of
plastic cover
g033119
3. On one edge of the access point, press both tabs away from the metal chassis while
simultaneously lifting that edge of the chassis away from the plastic cover.
Copyright © 2012, Juniper Networks, Inc.28
AX411 Access Point Hardware Guide

Jupiter AX411 Access Point Specifications

General

Brand	Jupiter
Model	AX411 Access Point
Category	Wireless Access Point
Language	English