Jupiter AX411 Access Point User Manual

Table 16: Access Point LED Starting Indications
StateRadio2Radio1StatusPower
The access point has just started up.BlueBlueOffRed
The access point is loading Uboot.BlueBlueOffOff
The access has finished loading Uboot.BlueBlueOffGreen
The access point has started and is
requesting an IP address with DHCP, but is
not yet being managed by SRX Series device
and has not received its configuration from
the SRX Series device.
OffOffOffGreen
The access point has received an IP address
is being managed by the SRX Series device
and has received its configuration from the
SRX Series device.
OffOffGreenGreen
Related
Documentation
Troubleshooting the AX411 Access Point with the LEDs on page 57•
• Monitoring the AX411 Access Point with the Command-Line Interface on page 52
Monitoring the AX411 Access Point with the Command-Line Interface
To monitor the AX411 Access Point with the command-line interface (CLI):
•
Use the show wlan access-points command to display a list of access points and basic
settings, as shown in the following example:
root@srx210–1> show wlan access-points
Active access points information
Access-Point Type Interface Radio-mode/Channel
gold Ext vlan an/36, bgn/6
silver Ext vlan an/56, bgn/11
•
To view detailed information about an access point, use the show wlan access-points
detail access-point-name command to display detailed information, as shown in the
following example:
root@srx210–1> show wlan access-points detail gold
Active access point detail information
Access Point : gold
Type : External
Location : Default Location
Serial Number : 850001761
Firmware Version : 10.1.2.3
Access Interface : vlan
Packet Capture : Disabled
Copyright © 2012, Juniper Networks, Inc.52
AX411 Access Point Hardware Guide

Jupiter AX411 Access Point Specifications

General

Brand	Jupiter
Model	AX411 Access Point
Category	Wireless Access Point
Language	English