admin@srx650–tp# set system services dhcp pool 192.168.6.0/24 address-range low
192.168.6.2 high 192.168.6.254
admin@srx650–tp# set system services dhcp pool 192.168.7.0/24 address-range low
192.168.7.2 high 192.168.7.254
admin@srx650–tp# set system services dhcp pool 192.168.8.0/24 address-range low
192.168.8.2 high 192.168.8.254
5. Configure DHCP address pools for each of the ports:
admin@srx650–tp# set system services dhcp pool 192.168.4.0/24 router 192.168.4.1
admin@srx650–tp# set system services dhcp pool 192.168.5.0/24 router 192.168.5.1
admin@srx650–tp# set system services dhcp pool 192.168.6.0/24 router 192.168.6.1
admin@srx650–tp# set system services dhcp pool 192.168.7.0/24 router 192.168.7.1
admin@srx650–tp# set system services dhcp pool 192.168.8.0/24 router 192.168.8.1
6. Add each logical interface to a valid security zone:
admin@srx650–tp# set security zones security-zone trust interfaces ge–1/0/0.0
admin@srx650–tp# set security zones security-zone trust interfaces ge–1/0/1.0
admin@srx650–tp# set security zones security-zone trust interfaces ge–1/0/2.0
admin@srx650–tp# set security zones security-zone trust interfaces ge–1/0/3.0
admin@srx650–tp# set security zones security-zone trust interfaces ge–1/0/4.0
7. Commit your changes:
admin@srx650–tp# commit
commit complete
Configuring AX411 Access Point Country-Specific Settings
Under most circumstances, you do not need to set any country-specific settings in order
to install, configure, and use the access point. However, the following two access point
versions are supplied with the country code set to a null value:
•
ETSI (SKU AX411-E)
•
Worldwide (SKU AX411-W)
For these units, you must set the country code and two other country-specific settings
before you can use the access point.
To configure the country code and the two other country-specific settings, perform one
of the following procedures before testing connectivity to the access point:
Copyright © 2012, Juniper Networks, Inc.42
AX411 Access Point Hardware Guide