General Information
1-2
1.3 Warranty information
Warranty information is located on the inside front cover of
this instruction manual. Should your Model 2001 require
warranty service, contact the Keithley representative or au-
thorized repair facility in your area for further information.
When returning the instrument for repair, be sure to fill out
and include the service form at the back of this manual to
provide the repair facility with the necessary information.
1.4 Manual addenda
Any improvements or changes concerning the instrument or
manual will be explained in an addendum included with the
manual. Be sure to note these changes and incorporate them
into the manual.
1.5 Safety symbols and terms
The following symbols and terms may be found on an instru-
ment or used in this manual.
The symbol on an instrument indicates that the user
should refer to the operating instructions located in the man-
ual.
The symbol on an instrument shows that high voltage
may be present on the terminal(s). Use standard safety pre-
cautions to avoid personal contact with these voltages.
The
WARNING
heading used in this manual explains dan-
gers that might result in personal injury or death. Always
read the associated information very carefully before per-
forming the indicated procedure.
The
CAUTION
heading used in this manual explains haz-
ards that could damage the instrument. Such damage may in-
validate the warranty.
1.6 Specifications
Full Model 2001 specifications are included in Appendix A.
1.7 Inspection
The Model 2001 was carefully inspected, both electrically
and mechanically before shipment. After unpacking all items
from the shipping carton, check for any obvious signs of
physical damage that may have occurred during transit.
(Note: There may be a protective film over the display lens,
which can be removed.) Report any damage to the shipping
agent immediately. Save the original packing carton for pos-
sible future reshipment. The following items are included
with every Model 2001 order:
• Model 2001 Multimeter (with MEM1 or MEM2 mem-
ory option, if ordered) with line cord.
• Model 8605 High Performance Modular Test Leads.
• Model 2001 Operator’s Manual and Model 2001 Cali-
bration Manual.
• Accessories as ordered.
• Full calibration data (conforming to MIL-STD
45662A).
If an additional manual is required, order the appropriate
manual package:
• Keithley part number 2001-900-00 for the Operator’s
Manual.
• Keithley part number 2001-905-00 for the Calibration
Manual.
• Keithley part number 2001-902-00 for the Repair Man-
ual.
The manual packages include a manual and any pertinent ad-
denda.
1.8 Options and accessories
The following options and accessories are available from
Keithley for use with the Model 2001.
Model 1050 Padded Carrying Case —
A carrying case for
a Model 2001 or a Model 7001. Includes handles and shoul-
der strap.
Models 2001/MEM1 and 2001/MEM2 —
These optional
configurations of the Model 2001 extend its storage capacity.
The MEM1 option has 32K-bytes for non-volatile storage of
five setups, and 7000 readings in compact format or 1400
readings in full format. The MEM2 option has 128K-bytes
for non-volatile storage of ten setups, and 30000 compact
readings or 6000 full readings.
Model 2001-SCAN —
This is a 10-channel scanner card
that installs within the Model 2001. It has eight channels of
2-pole relay switching and two channels of 2-pole solid-state
switching. All channels can be configured for 4-pole opera-
tion. Included are two pairs of leads for connection to Model
2001 rear panel inputs (Keithley part number CA-109).
!
To Next Page
Loading...
Need help?
General
