Keithley 2001 User Manual

IEEE-488 Reference
4-67
Format
:calc2:stat <b>
Defaults
Power-up Saved power-on setup
*RST OFF
:SYSTem:PRESet OFF
Query
:STATe? Query state (on or off) of CALC 2
Short-form format: :calc2:stat?
Response message: 1 (on) or 0 (off)
Description
This command is used to enable or disable the CALC 2 calculation. When enabled, the selected
CALC 2 format will be calculated when the :IMMediate or :IMMediate? command is executed.
Programming example
10 OUTPUT 716; “:calc2:stat on; stat?”
20 ENTER 716; A$
30 PRINT A$
40 END
Line 10 Two commands in this program message; the first enables the CALC 2 calculation
and the second queries the programmed state.
Line 20 Addresses the Model 2001 to talk.
Line 30 Displays the state of CALC 2 (1; on).
:IMMediate
:CALCulate2:IMMediate Perform CALC 2
Format
:calc2:imm
Query
:IMMediate? Perform calculation and read result
(equivalent to :CALCulate2:IMMediate; DATA?)
Short-form format: :calc2:imm?
Response message: Result of calculation
Description
The :IMMediate command is used to perform the selected CALC 2 operation on the readings in
the buffer (assuming CALC 2 is enabled; see :STATe). After performing the calculation, the re-
sult can be read by using the :CALCulate2:DATA? query command.
An alternate way to perform the calculation and read the result is by using the query form of the
command (:IMMediate?). When this command is sent, the calculation is performed and the re-
sult is queried. The result of the calculation will be sent to the computer when the Model 2001
is addressed to talk.
Programming example
This example assumes that there are readings stored in the buffer and CALC 2 is enabled:
10 OUTPUT 716; “:calc2:form max”
20 OUTPUT 716; “:calc2:imm?”
30 ENTER 716; A$
40 PRINT A$
50 END
Line 10 Selects the MAX math format.

Keithley 2001 Specifications

General

Brand	Keithley
Model	2001
Category	Multimeter
Language	English