Kenwood DNX6180 User Manual

DNX7180/DNX7480BTIDNX6980/DNX6180/DNX6040EX/DNX6480BTIDNX5180
Installation Procedure
Unit
Bend the tabs of the
mounting sleeve
with a screwdriver
or similar utensil and
attach it in place.
Q]) ••• 1
@ ••. llillED~
® ... ll-]~.:D
To prevent a short circuit, remove
Supplied accessories
the key from the ignition and
disconnect the
e terminal of the
First of all, make sure that all
battery.
accessories are supplied with the
2 Make the proper input and
unit.
output wire connections for each
CD ••• 1
(j) ...6
unit.
3 Connect the speaker wires of the
~
wiring harness.
4 Connect the wiring harness wires
in
the following order;
ground, battery, ignition.
@ ... ll-H.: ••
® ... 6
5 Connect the wiring harness
connector
to the unit.
~
6 Install the unit in your car.
7 Reconnect the e terminal of the
battery.
8 Press the <Reset> button.
W ... ll-HED
® ... 1
9 Perform the Initial Setup.
r;:J
See FirstStep (P.6).
• Non-Japanese cars
® ... 2
@ ••• 1
Continued
-23-

Kenwood DNX6180 Specifications

General

Brand	Kenwood
Model	DNX6180
Category	GPS
Language	English