126
FUEL, COOLANT AND LUBRICANTS
4.3.1 HOMOLOGATED HEES SYNTHETIC BIODEGRADABLE LUBRICANTS
Our machines can be filled with synthetic biodegradable hydraulic oil type HEES not of plant origin and therefore
the use of the oils indicated in the following table is authorized and recommended :
CAUTION
• It is not possible to mix the synthetic biodegradable oil type HEES with ordinary hydraulic oils, since
when the temperature increases insoluble compounds are generated, which are deposited on the fil-
ters and clog them (the maximum concentration of ordinary oil cannot exceed 1% of the total quantity
of oil).
• The synthetic biodegradable oil can be used only in the hydraulic system; it cannot be used for the en-
dothermic motor, the transmissions, the braking system, etc.
• Before introducing the synthetic biodegradable oil in the hydraulic system, empty the system com-
pletely, disconnecting the cylinders and all the parts that may contain ordinary oil, and replace the
drain filter with a new one.
Start the engine and let it idle without using the work equipment , wait until the oil reaches a tempera-
ture of at least 40°C, then start moving the equipment, so that all the parts of the system are filled with
oil. Stop the engine and check the oil level (see “4.7.3.e CHECKING THE HYDRAULIC SYSTEM OIL LEV-
EL”).
SUPPLIER HEES SYNTHETIC BIODEGRADABLE OIL
KOMATSU BO 46 G4 (KES 07.872)
AGIP —
ARAL —
AVIA —
BP —
CONDAT CONDAT D 46 K
ELF —
ESSO —
FINA BIOHYDRAN SE 46
FUCHS —
KENDALL —
KUWAIT PETROLEUM K8 —
MOBIL EAL SYNDRAULIC
MOBIL (USA) —
PAKELO —
PANOLIN HLP SYNTH 46
SHELL NATURELLE HFX-32
TAMOIL —
TEXACO —
TOTAL HYDROBIO 46
VALVOLINE —
To Next Page
Loading...
Need help?
General
