22 TROUBLESHOOTING 209
Faults Possible cause Action
The combination instrument shows
nothing on the display
Fuse 1 is blown – Change the fuses in the fuse box. ( p. 181)
The main fuse is blown – Change the main fuse. ( p. 178)
The battery is discharged – Recharge the battery. ( p. 173)
– Check the open-circuit current.
The engine does not turn if the emer-
gency OFF switch/electric starter but-
ton is pressed into the lower position
Operating error – Carry out the start procedure. ( p. 92)
The battery is discharged – Recharge the battery. ( p. 173)
– Check the open-circuit current.
The safety start system is faulty – Read out the fault memory using the KTM diag-
nostics tool.
Electronic fault – Read out the fault memory using the KTM diag-
nostics tool.
The engine only turns if the clutch
lever is drawn
The vehicle is in gear – Shift the transmission to idle .
The safety start system is faulty – Read out the fault memory using the KTM diag-
nostics tool.
The engine turns although a gear is
engaged
The safety start system is faulty – Read out the fault memory using the KTM diag-
nostics tool.
The engine turns but does not start The coupling of the fuel hose connec-
tion is not connected
– Reconnect the coupling of the fuel hose connec-
tion.
Defect in the fuel injection system – Read out the fault memory using the KTM diag-
nostics tool.
The fuel quality is insufficient – Add suitable fuel.
The engine dies during the trip Lack of fuel – Refuel. ( p. 106)
Defect in the fuel injection system – Read out the fault memory using the KTM diag-
nostics tool.
Malfunction indicator lamp lights up or
flashes
Defect in the fuel injection system – Read out the fault memory using the KTM diag-
nostics tool.
To Next Page
Loading...
Need help?
General
