PERIODIC SERVICE124
BChecking Gauges, Meter and Easy
Checker(TM)
1. Inspect the instrument panel for broken gauge(s),
meter(s) and Easy Checker (TM).
2. Replace if broken.
BChecking Head Light, Turn Signal / Hazard
Light etc.
1. Inspect the lights for broken bulbs and lenses.
2. Replace if broken.
BChecking Seat Belt
1. Always check condition of seat belt attaching
hardware before operating tractor.
2. Replace if damaged.
BChecking Movable Parts
If any of the movable parts, such as levers and pedals, is
not smoothly moved because of rust or sticky material, do
not attempt to force it into motion.
In the above case, remove the rust or the sticky material,
and apply oil or grease on the relevant spot.
Otherwise, the machine may get damaged.
INITIAL 50 HOURS
BChanging Engine Oil
(See "Changing Engine Oil" in "EVERY 500 HOURS" in
"PERIODIC SERVICE" section for this service.)
BReplacing Engine Filter
(See "Replacing Engine Oil Filter" in "EVERY 500
HOURS" in "PERIODIC SERVICE" section for this
service.)
BChecking Fan / Air-conditioner Belt
Tension
[M6-131, M6-141]
(See "Checking Fan/Air-conditioner Belt Tension" in
"EVERY 400 HOURS" in "PERIODIC SERVICE" section
for this service.)
EVERY 50 HOURS
BChecking Engine Start System
To avoid personal injury or death:
A Do not allow anyone near the tractor while
testing.
A If the tractor does not pass the test, do not
operate the tractor.
C Preparation before testing.
1. Place all control levers in the "NEUTRAL" position.
2. Set the parking brake and stop the engine.
C Test: Switch for the Power shift / Range shift lever.
1. Follow the instruction of "PARKING THE TRACTOR".
(See "PARKING THE TRACTOR" in "SAFE
OPERATION" section.)
2. Sit on the operator's seat.
3. Shift the Power shift / Range shift lever to the desired
position.
4. Depress the clutch pedal fully.
5. Disengage the PTO clutch control switch or lever.
6. Turn the key to "START" position.
7. The engine must not crank.
8. If it cranks, consult your local KUBOTA Dealer for this
service.
C Test: Switch for the PTO clutch control switch or
lever.
1. Follow the instruction of "PARKING THE TRACTOR".
(See "PARKING THE TRACTOR" in "SAFE
OPERATION" section.)
2. Sit on the operator's seat.
3. Engage the PTO clutch control switch or lever.
4. Depress the clutch pedal fully.
5. Shift the Power shift / Range shift lever to the neutral
position.
6. Turn the key to "START" position.
7. The engine must not crank.
8. If it cranks, consult your local KUBOTA Dealer for this
service.
With a new machine, be sure to do the servicing, as
discussed below, after the first 50 operating hours.
To Next Page
Loading...
Need help?
General
